LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 161 (Engine Controls - System/Component Tests - EEC-IV (5.8L)) >> Emission Systems & Subsystems >> Fuel Evaporation >> Canister Purge (CANP) Solenoid

Canister Purge (CANP) Solenoid

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1995 Ford RV Cutaway, 1995 Ford Pickup, 1995 Ford Econoline, 1995 Ford Cutaway, and 1995 Ford Club Wagon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect CANP solenoid harness connector. Set DVOM to 200-ohm scale. Measure resistance across CANP solenoid terminals. Resistance should be 30-90 ohms. If resistance is not as specified, replace CANP solenoid.
  2. Disconnect vacuum hose at CANP solenoid on manifold vacuum side. Apply 16 in. Hg vacuum to manifold vacuum side of solenoid. CANP solenoid should hold vacuum for 20 seconds.
  3. Faults in CANP solenoid or circuit should set a trouble code. See QUICK TEST in TESTS W/CODES - EEC-IV (5.8L) article. If no trouble code has been set, see CIRCUIT TEST KD in the TESTS W/CODES - EEC-IV (5.8L) article for additional solenoid and circuit testing.
scientia non olet · About LEMON Manuals