Relays & Solenoids: Solenoids: Notes
WARNING: This page is about a different car, the 1995 Ford Pickup, 1995 Ford Econoline, 1995 Ford Club Wagon, and 1995 Ford Bronco. However, it is still accessible from the selected car via links, so may be relevant.
Secondary Air Injection By-pass/Diverter (AIRB/AIRD) Solenoids -Disconnect solenoid harness connector, and measure resistance across terminals. Resistance should be 50-100 ohms. If resistance is not as specified, replace solenoid. Faults in solenoid or circuit should set a diagnostic trouble code. See QUICK TEST in TESTS W/CODES - EEC-IV (5.0L) article. If no diagnostic trouble code has been set, proceed to CIRCUIT TEST KC in the appropriate TESTS W/CODES - EEC-IV (5.0L) article for additional solenoid and circuit testing.