LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 156 (7.3L V8 Diesel - VIN [F]) >> Removal & Installation >> Water Pump >> Removal

Water Pump: Removal

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1995 Ford RV Cutaway, 1995 Ford Pickup, 1995 Ford F-Super Duty, 1995 Ford Econoline, and 1995 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable from both batteries. Partially drain cooling system. On Van, remove air cleaner assembly. On all models, remove upper radiator hose. Disconnect coolant recovery hose from radiator.
  2. Disconnect fan shroud and place over fan. Using Fan Clutch Pulley Holder (T94T-6312-AH) and Fan Clutch Nut Wrench (T83T-6312-B), remove fan, clutch assembly and fan shroud. Loosen water pump pulley and remove drive belt.
  3. Remove water pump pulley. Disconnect engine coolant temperature sensor. Disconnect heater hose from water pump. Remove water pump inlet fitting from water pump. Note bolt location and remove water pump bolts. Remove water pump.