Removal & Installation: Flywheel: Removal
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1995 Ford RV Cutaway, 1995 Ford Pickup, 1995 Ford F-Super Duty, 1995 Ford Econoline, and 1995 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- On A/T models, a standard type flywheel is used. On M/T models a dual mass flywheel is used. Dual mass flywheel is consists of 2 flywheels. See Figure. On all models, remove transmission. See REMOVAL & INSTALLATION - A/T article under TRANSMISSION SERVICING or REMOVAL & INSTALLATION - M/T article (for M/T models).
- On A/T models, remove flywheel-to-crankshaft bolts and flywheel. On M/T models, remove clutch assembly from flywheel. Remove 2flywheel-to-crankshaft bolts and install guide studs. Remove remaining flywheel-to-crankshaft bolts. Remove reinforcing plate, secondary flywheel and primary flywheel. Remove secondary flywheel bolts and separate primary flywheel from secondary flywheel.