Removal & Installation: Flywheel: Inspection
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1995 Ford RV Cutaway, 1995 Ford Pickup, 1995 Ford F-Super Duty, 1995 Ford Econoline, and 1995 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- On A/T models, inspect flywheel and starter ring for damage. Replace flywheel if damaged.
- On M/T models, inspect secondary flywheel for grooves or damaged areas in clutch disc area. Resurface secondary flywheel as necessary. Replace secondary flywheel if secondary flywheel thickness is less than 1.41" (35.8 mm) after machining, or more than.060" (1.52 mm) is machined from original thickness on secondary flywheel.
CAUTION:
DO NOT use secondary flywheel if secondary flywheel thickness is less than 1.41" (35.8 mm) after machining, as this may cause damage to primary flywheel.