Crankshaft Rear Oil Seal: Installation
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1995 Ford RV Cutaway, 1995 Ford Pickup, 1995 Ford F-Super Duty, 1995 Ford Econoline, and 1995 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Clean engine block gasket surfaces. Remove old silicone sealer from oil pan sealing surface. Clean surface with solvent and dry thoroughly. Apply silicone sealer to rear oil seal retaining ring and 5 crankshaft rear oil seal retaining bolts.
- Using Crankshaft Seal Replacer (T94T-6701-AH3), Crankshaft Seal Replacer (T94T-6701-AH4), Driver Sleeve (T79T-6316-A4) and Guide Pins (T94P-7000-P), install crankshaft wear ring and rear oil seal.
- Install rear oil seal retaining bolts and tighten to specification. See TORQUE SPECIFICATIONS . Remove installation tools. To complete installation, reverse removal procedure.