LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 156 (7.3L V8 Diesel - VIN [F]) >> Removal & Installation >> Cooling System Bleeding

Cooling System Bleeding

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 1995 Ford RV Cutaway, 1995 Ford Pickup, 1995 Ford F-Super Duty, 1995 Ford Econoline, and 1995 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: When engine is operating, NEVER remove radiator cap under any conditions. Failure to follow instruction could damage cooling system or engine, and cause personal injury. Always wrap protective material around radiator cap to avoid injury from hot steam or hot coolant.
  1. Fill cooling system with 50/50 mixture of water and coolant. Pause several minutes for circulation. Fill radiator to filler neck seat. Disconnect heater outlet hose at water pump to bleed off trapped air. Fill radiator until coolant begins to escape.
  2. Connect heater outlet hose. Fill radiator until coolant is between cap seal in filler neck to 1.5" (38 mm) below cap seal. Install radiator cap. Start engine and allow to warm. Shut off engine. Allow engine to cool. Remove radiator cap and check coolant level. Top off radiator coolant as necessary.
scientia non olet · About LEMON Manuals