Oil Pan: Installation
WARNING: This page is about a different car, the 1995 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.
To install, reverse removal procedure. Before installing oil pan, apply Silicone Sealant (F1AZ-19562-A) on oil pan rails of cylinder block, rear main bearing cap and front cover-to-cylinder block areas. Tighten oil pan bolts to specification. See, in this article, TORQUE SPECIFICATIONS . Fill oil system.
CAUTION:
Ensure silicone sealant fills groove between rear main bearing cap and cylinder block at both edges of main bearing cap.