LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (3.8L V6 - VIN [4]) >> Removal & Installation >> Engine >> Installation

Removal & Installation: Engine: Installation

WARNING: This page is about a different car, the 1995 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse removal procedure. Tighten bolts and nuts to specification. See TORQUE SPECIFICATIONS  .
  2. When installing fuel lines, install new "O" rings on fuel lines. Use only specified fuel resistant "O" rings (Brown). Lightly coat "O" rings with clean engine oil before installing. Clean fittings, and replace garter spring (if necessary).
  3. Adjust control cables and fluid levels. Refill cooling system. Evacuate and recharge A/C system. Check wheel alignment. See SPECIFICATIONS & PROCEDURES article in WHEEL ALIGNMENT.
scientia non olet · About LEMON Manuals