Crankshaft Rear Oil Seal: Installation
WARNING: This page is about a different car, the 1995 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.
- Lubricate seal and mating surfaces with engine oil. Install seal on crankshaft with spring side toward crankshaft. Using Seal Installer (T82L-6701-A), alternate bolt tightening to install seal properly.
- To install remaining components, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS .
CAUTION:
Apply thread sealant on threads of drive plate or flywheel bolts before installing.