Crankshaft Front Oil Seal: Removal
WARNING: This page is about a different car, the 1995 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.
- Rotate drive belt tensioner, and remove drive belt. Raise and support vehicle. Remove wheel assembly. Remove crankshaft pulley from vibration damper. Place reference mark on crankshaft pulley and vibration damper. Remove vibration damper retaining bolt.
- Using Vibration Damper Remover (T58P-6316-D) and Adapter (T82L-6316-B), remove vibration damper. Using screwdriver, pry seal from front cover.