LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (3.8L V6 - VIN [4]) >> Removal & Installation >> Camshaft >> Installation

Removal & Installation: Camshaft: Installation

WARNING: This page is about a different car, the 1995 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse removal procedure. Ensure oil holes in camshaft bearings and cylinder block align. Apply sealant to rear camshaft bore plug before installing.
    NOTE: Oversize rear camshaft bore plug can be identified by oversize stamped on flat area of plug. Ensure proper size plug is installed.
  2. Lubricate camshaft lobes and bearing surfaces with Assembly Lubricant (D9AZ-19579-D). Install camshaft. Tighten thrust plate bolts to specification. See TORQUE SPECIFICATIONS  .
  3. Ensure camshaft end play is within specification. See CAMSHAFT  table under ENGINE SPECIFICATIONS. To complete installation, reverse removal procedure. Refill cooling system.
scientia non olet · About LEMON Manuals