Cylinder Block Specifications
WARNING: This page is about a different car, the 1995 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.
CYLINDER BLOCK
| Application | In. (mm) | |||
|---|---|---|---|---|
| Cylinder Bore | ||||
| Standard Diameter | 3.81 (96.8) | |||
| Maximum Taper | .002 (.05) | |||
| Maximum Out-Of-Round | .002 (.05) | |||
| Maximum Deck Warpage | (1) .003 Per 6 (.08 Per 152) | |||
| Balance Shaft Bore I.D. | 2.191-2.192 (55.651-55.677) | |||
| Camshaft Bearing I.D. | 2.0525-2.0535 (52.134-52.159) | |||
| Camshaft Bearing Bore I.D. | ||||
| No. 1 & 4 | 2.191-2.192 (55.651-55.671) | |||
| No. 2 & 3 | 2.176-2.177 (55.270-55.296) | |||
| Main Bearing Bore | 2.712-2.713 (68.88-68.91) | |||
|
||||