Rear Crankshaft Oil Seal: Removal
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1995 Ford RV Cutaway, 1995 Ford Pickup, 1995 Ford F-Super Duty, 1995 Ford Econoline, and 1995 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Remove oil pan. See OIL PAN . Loosen all main bearing cap bolts to slightly lower crankshaft. DO NOT lower more than 1/32" (.79 mm). Remove rear main bearing cap and lower oil seal half. Use seal remover to remove upper seal.
- If seal remover is not available, install a small metal screw in one end of seal. Carefully pull on screw to remove seal without damaging sealing surface.