Removal (Lower)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1995 Ford RV Cutaway, 1995 Ford Pickup, 1995 Ford F-Super Duty, 1995 Ford Econoline, and 1995 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative battery cable. On E350 Vans and F250/F350 Pickups, remove upper intake manifold as previously described. Position No. 1 piston on TDC of compression stroke. Remove distributor cap and wires. Mark distributor location for installation reference. Remove distributor.
- Remove air cleaner and duct assembly. Release fuel system pressure. See FUEL PRESSURE RELEASE . Using Spring Lock Coupling Remover (T81P-19623-G1 for 3/8" line or T81P-19623-G2 for 1/2" line), disconnect fuel supply and return lines. See Figure.
- Remove upper radiator hose. Disconnect coolant hoses at intake manifold and water pump. Label and disconnect vacuum hoses as necessary. Remove both thermactor exhaust air supply tubes. Remove ignition coil and mounting bracket.
- Disconnect wiring harness from main wiring. Remove wiring harness and lower intake manifold as an assembly. Label and disconnect all other electrical wiring from intake manifold. Remove attaching bolts, and lift lower intake manifold and throttle body as an assembly.