Camshaft Bearings: Installation
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1995 Ford RV Cutaway, 1995 Ford Pickup, 1995 Ford F-Super Duty, 1995 Ford Econoline, and 1995 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Using camshaft bearing remover/installer, install bearings into place. Ensure oil holes in bearings and cylinder block are aligned. Install front bearing .002-.003" (.051-.076 mm) below front face of cylinder block. Coat NEW rear bore plug with sealer and install. To complete installation, reverse removal procedure.