LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 151 (7.5L V8 - VIN [G]) >> Overhaul >> Cylinder Block Assembly >> Rod Bearings

Rod Bearings

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1995 Ford RV Cutaway, 1995 Ford Pickup, 1995 Ford F-Super Duty, 1995 Ford Econoline, and 1995 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Use Plastigage to check rod bearing clearance. If proper oil clearance cannot be obtained with standard bearings, try a combination of undersize bearings. DO NOT use any bearing combination other than those listed. See UNDERSIZE MAIN & ROD BEARING COMBINATIONS table.
  2. If use of bearing combinations does not bring clearance within specification, machine or replace crankshaft as necessary. Always replace bearings in pairs. Refer to, in this article, CRANKSHAFT MAIN & CONNECTING ROD BEARINGS  table under ENGINE SPECIFICATIONS.
UNDERSIZE MAIN & ROD BEARING COMBINATIONS (1)

Excess Bearing Clearance: In. (mm) Use Upper Bearing: In. (mm) Use Lower Bearing: In. (mm)
.0-.0005 (.0-.013) .001 (.025) (2)
.0005-0010 (.013-.025) .001 (.025) .001 (.025)
.0010-.0015 (.025-.039) .002 (.050) .001 (.025)
.0015-.0020 (.039-.050) .002 (.050) .002 (.050)
(1) DO NOT use any bearing combination other than those listed. If use of bearing combinations does not bring clearance within specification, machine or replace crankshaft as necessary.
(2) Use standard bearing.
scientia non olet · About LEMON Manuals