LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 148 (5.8L V8 - VIN [H]) >> Removal & Installation >> Timing Chain Cover >> Removal (Van)

Removal (Van)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1995 Ford RV Cutaway, 1995 Ford Pickup, 1995 Ford Econoline, 1995 Ford Cutaway, and 1995 Ford Club Wagon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain cooling system. Remove upper and lower radiator hoses. Remove radiator. Remove cooling fan and shroud. Raise vehicle on hoist. Remove A/C compressor, power steering pump bracket and accessories. Remove crankshaft pulley.
  2. Remove crankshaft damper using Crankshaft Damper Remover (T79T-6316-A). Remove oil pan-to-timing chain cover bolts. Remove timing chain cover and water pump as an assembly.
  3. If replacement of timing chain cover seal is necessary, drive out old seal with pin punch, taking care not to damage timing chain cover seal recess. Cut oil pan gasket even with cylinder block.
scientia non olet · About LEMON Manuals