LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 148 (5.8L V8 - VIN [H]) >> Removal & Installation >> Timing Chain Cover >> Removal (Bronco & Pickup)

Removal (Bronco & Pickup)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1995 Ford RV Cutaway, 1995 Ford Pickup, 1995 Ford Econoline, 1995 Ford Cutaway, and 1995 Ford Club Wagon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain cooling system. Loosen fan clutch bolts. Remove fan shroud-to-radiator bolts (if equipped), and position shroud aside. Remove idler pulley belt. Remove all hoses and brackets attached to water pump.
  2. Remove fan, clutch and pulley. Remove fan shroud (if equipped). Remove crankshaft pulley bolt. Remove crankshaft pulley. Remove crankshaft damper using Crankshaft Damper Remover (T79T-6316-A). Remove oil pan-to-cylinder block timing chain cover bolts. Remove timing chain cover and water pump as an assembly.
  3. Cut oil pan gasket even with cylinder block. If replacement of timing chain cover seal is necessary, drive out old seal with pin punch. DO NOT damage timing chain cover seal recess.
scientia non olet · About LEMON Manuals