LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 148 (5.8L V8 - VIN [H]) >> Removal & Installation >> Crankshaft Rear Oil Seal >> Removal

Crankshaft Rear Oil Seal: Removal

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1995 Ford RV Cutaway, 1995 Ford Pickup, 1995 Ford Econoline, 1995 Ford Cutaway, and 1995 Ford Club Wagon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable and remove starter. Remove transmission. Remove flywheel/flexplate and engine rear cover plate. Using a sharp awl, punch a hole into seal metal surface, between lip and block.
  2. Using Carburetor Jet Plug Puller (T77L-9533-B), screw in threaded end of puller. Remove rear oil seal.
CAUTION: DO NOT scratch crankshaft or sealing surface during seal removal procedure.
scientia non olet · About LEMON Manuals