LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 148 (5.8L V8 - VIN [H]) >> Removal & Installation >> Crankshaft Front Seal >> Removal

Crankshaft Front Seal: Removal

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1995 Ford RV Cutaway, 1995 Ford Pickup, 1995 Ford Econoline, 1995 Ford Cutaway, and 1995 Ford Club Wagon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove fan shroud attaching bolts. Remove fan, clutch and shroud. Remove serpentine drive belt. Remove crankshaft pulley from the crankshaft vibration damper. Remove damper bolt and washer.
  2. Remove crankshaft damper using Crankshaft Damper Remover (T79T-6316-A). Place Seal Remover (T70P-6B070-B) onto timing chain cover plate over front seal.
  3. Tighten 2 through-bolts, forcing seal remover under seal flange. Alternately tighten puller bolts one-half turn at a time until seal is removed from engine.
scientia non olet · About LEMON Manuals