LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 148 (5.8L V8 - VIN [H]) >> Lubrication >> Oil Pump >> Reassembly & Installation

Reassembly & Installation

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1995 Ford RV Cutaway, 1995 Ford Pickup, 1995 Ford Econoline, 1995 Ford Cutaway, and 1995 Ford Club Wagon. However, it is still accessible from the selected car via links, so may be relevant.
  1. To reassemble, reverse disassembly procedure. Ensure components are installed in original location. Install NEW oil pressure relief valve cap. To install, prime oil pump by filling inlet opening with oil, and rotating pump shaft until oil emerges from outlet opening.
  2. Install and tighten oil pump-to-cylinder block bolt to specification. See TORQUE SPECIFICATIONS. To complete installation, reverse removal procedure.
CAUTION: If pump and drive shaft do not seat readily, DO NOT force into position. Realign drive shaft hex with distributor shaft socket and reinstall.
scientia non olet · About LEMON Manuals