Oil Pan: Installation
WARNING: This page is about a different car, the 1995 Ford Pickup, 1995 Ford Econoline, 1995 Ford Club Wagon, and 1995 Ford Bronco. However, it is still accessible from the selected car via links, so may be relevant.
To install, reverse removal procedure. Apply silicone sealant at front and rear corners of oil pan surface and cylinder block, and where timing chain cover meets cylinder block. To install remaining components, reverse removal procedure.
- Apply silicone sealant at front and rear corners of oil pan surface and cylinder block, and where timing chain cover meets cylinder block. Position NEW gasket and seals to engine block.
- Position oil pan with pump to engine, and install oil pump. To complete installation, reverse removal procedure. Fill or top off all fluids. Fill and bleed air from cooling system. Refer to COOLING SYSTEM BLEEDING .