LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (5.0L V8 - VIN [N]) >> Removal & Installation >> Crankshaft Front Seal >> Removal

Crankshaft Front Seal: Removal

WARNING: This page is about a different car, the 1995 Ford Pickup, 1995 Ford Econoline, 1995 Ford Club Wagon, and 1995 Ford Bronco. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove fan shroud attaching bolts. Remove fan, clutch and shroud. Remove serpentine drive belt. Remove crankshaft pulley and damper. Place Seal Remover (T70P-6B070-B) onto timing chain cover plate over front seal.
  2. Tighten 2 through-bolts, forcing seal remover under seal flange. Alternately tighten puller bolts one-half turn at a time until seal is removed from engine.
scientia non olet · About LEMON Manuals