LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Engine - 4.9L 6-CYL - VIN [Y]) >> Removal & Installation >> Timing Gear Cover >> Removal

Timing Gear Cover: Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1996 Ford Pickup, 1996 Ford Econoline, 1996 Ford Club Wagon, 1996 Ford Cab & Chassis, and 1995 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain cooling system and crankcase. Remove shroud and radiator. Remove drive belt. Using Fan Clutch Pulley Holder (T84T-6312-C) and Fan Clutch Nut Wrench (T93T-6312-B), remove fan and clutch assembly.
  2. Remove A/C compressor and position aside. Remove power steering pump and bracket and position aside. Remove crankshaft damper retaining bolt and washer. Using Vibration Damper Remover (T58P-6316-D), remove vibration damper.
  3. Remove timing gear cover and front oil pan bolts. Loosen first 6 bolts on each side of oil pan. Lightly push down oil pan to relieve pressure on timing gear cover. Remove timing gear cover and gasket.
NOTE: Always replace timing gear cover oil seal whenever timing gear cover is removed.
scientia non olet · About LEMON Manuals