LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Engine - 4.9L 6-CYL - VIN [Y]) >> Removal & Installation >> Crankshaft Rear Oil Seal >> Removal

Crankshaft Rear Oil Seal: Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1996 Ford Pickup, 1996 Ford Econoline, 1996 Ford Club Wagon, 1996 Ford Cab & Chassis, and 1995 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove starter and transmission. For A/T models, see TRANSMISSION REMOVAL & INSTALLATION article in TRANSMISSION SERVICING. For M/T models, see HYDRAULIC article in CLUTCHES.
  2. On all models, remove clutch assembly (if equipped). Remove flexplate/flywheel. Remove engine rear cover plate. Using an awl, punch hole in oil seal metal surface between lip and block.
  3. Carefully pry oil seal from recess without damaging seal surface. Clean oil seal recess in block and main bearing cap.
scientia non olet · About LEMON Manuals