LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Engine - 4.9L 6-CYL - VIN [Y]) >> Removal & Installation >> Crankshaft Front Seal >> Removal

Crankshaft Front Seal: Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1996 Ford Pickup, 1996 Ford Econoline, 1996 Ford Club Wagon, 1996 Ford Cab & Chassis, and 1995 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove fan and shroud. Remove drive belt. Remove crankshaft damper retaining bolt and washer. Using puller, remove vibration damper. Position Oil Seal Remover (T70P-6B070-B) onto seal, and tighten 2 through-bolts to force seal puller under the seal flange.
  2. Alternately tighten 4 puller bolts 1/2 turn at a time. Remove oil seal from the timing gear cover. Clean seal recess in timing gear cover.
scientia non olet · About LEMON Manuals