LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Engine - 4.9L 6-CYL - VIN [Y]) >> Removal & Installation >> Camshaft Bearings >> Removal

Camshaft Bearings: Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1996 Ford Pickup, 1996 Ford Econoline, 1996 Ford Club Wagon, 1996 Ford Cab & Chassis, and 1995 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove engine. See ENGINE . Install engine on engine stand. Remove flywheel/flexplate. Remove camshaft rear bearing bore plug.
  2. Remove camshaft and crankshaft. See CAMSHAFT  and CRANKSHAFT  . Push pistons to top of cylinders. Using Camshaft Bearing Remover/Installer (T65L-6250-A), remove cam bearings. To remove front bearing, place bearing puller in cam bore from rear of cylinder block.
scientia non olet · About LEMON Manuals