Water Pump: Removal
WARNING: This page is about a different car, the 1995 Ford Aerostar. However, it is still accessible from the selected car via links, so may be relevant.
- Remove negative battery cable. Drain cooling system. Disconnect lower radiator hose and heater return hose from water pump. Using Fan Clutch Pulley Holder (T84T-6312-C) and Fan Clutch Nut Wrench (T84T-6312-D), remove radiator fan and clutch assembly. See Figure.CAUTION: Fan clutch nut has left-hand threads. Remove nut by turning it clockwise as viewed from front of engine.
- Remove accessory drive belt. Remove power steering pump with bracket and A/C compressor (if equipped), and position aside. Remove generator bracket with generator, and position aside. Remove water pump pulley. Remove water pump bolts, and remove pump. Remove gasket.