Ignition Timing (Villager)
WARNING: This page is about a different car, the 1995 Mercury Villager, 1995 Ford Windstar, 1995 Ford Ranger, and 1995 Ford Aerostar. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure engine is at normal operating temperature. Turn ignition off. Disconnect Throttle Position (TP) sensor.
- Start engine. Increase engine speed to 2000 RPM, 2 or 3 times, then allow the engine to return to idle. Check ignition timing. Refer to the specifications in the V6 IGNITION TIMING table. Also, See Fig 1. If ignition timing is in correct, loosen hold-down bolt and turn crankshaft position sensor.
V6 IGNITION TIMING
| Application | M/T (°BTDC @ RPM) | (1) A/T (°BTDC @ RPM) | ||
|---|---|---|---|---|
| Villager | 13-17 @ 550-650 | 13-17 @ 600-700 | ||
|
||||