Diagnostic Aids

WARNING: This page is about a different car, the 1995 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.

Perform this test when instructed during QUICK TEST or if directed by other test procedures. This test is used to diagnose the following:

Faulty Powertrain Control Module (PCM).

1) DTC P1359: Check VREF Circuit Voltage At TP Sensor

Turn ignition off. Disconnect TP sensor wiring harness connector. Turn ignition on. Measure voltage between SIG RTN terminal and VREF terminal at wiring harness connector. If voltage is 4-6 volts, go to next step. If voltage is not 4-6 volts, go to CIRCUIT TEST C .

2) Check CKP Sensor

Turn ignition off. Check CKP sensor and trigger wheel for damage or mis-alignment. Repair or replace as necessary. If no faults are found, replace PCM and repeat QUICK TEST .