LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 119 (Engine Controls - Tests W/Codes) >> Self-Diagnostic System >> Retrieving Codes >> Malfunction Indicator Light (MIL)

Malfunction Indicator Light (MIL)

WARNING: This page is about a different car, the 1995 Mercury Villager. However, it is still accessible from the selected car via links, so may be relevant.

Trouble codes are retrieved from EEC system through MIL (CHECK ENGINE light) located on instrument panel. MIL is used with Diagnostic Test Connector (DTC) located near starter motor. Figure . To retrieve codes, use the following procedure:

  1. Turn ignition key to ON position. Disconnect the diagnostic connector in engine compartment. Jumper terminals as indicated in illustration, and wait 2 seconds.Figure .
  2. Remove jumper wire and reconnect diagnostic connector. Record DTC, MIL flashes.

scientia non olet · About LEMON Manuals