LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - 3.0L V6 - VIN [U] >> Removal & Installation >> Camshaft Bearings >> Installation

Camshaft Bearings: Installation

NOTE: When installing NEW camshaft bearings, ensure 2 larger outside diameter bearings are installed in front and rear bores.
  1. Align oil hole in bearing with oil hole in bearing bore. Using camshaft bearing remover/installer, install NEW camshaft bearings. Ensure front bearing is installed .020-.035" (.51-.89 mm) below front face of cylinder block.
  2. Coat sealing edge of NEW rear camshaft bearing bore plug with oil resistant sealer and install bore plug. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals