LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Drive Shaft >> Overhaul >> Single CARDAN Universal Joints >> Reassembly & Installation

Reassembly & Installation

  1. Coat roller and bearing assemblies with lubricant, and fill reservoirs in ends of cross. Install cross into drive shaft yoke. Install roller and bushing assemblies into position.
  2. Press both bushing assemblies into yoke until retainers can be installed, keeping cross aligned in center of bushings. Install retainers. Repeat procedure for remaining bushings. Install strap (if equipped). Install drive shaft into vehicle, aligning scribe marks.
scientia non olet · About LEMON Manuals