7.5" & 8.8" Differential
WARNING:
Preload spring is under pressure; remove carefully.
NOTE:
Thrust washers cannot be removed alone. They must be rotated out of case with pinion gears.
- Remove ring gear. DO NOT remove ABS sensor ring (if equipped). If sensor ring is removed, it must be replaced. Remove pinion shaft lock bolt and pinion shaft. Grasp preload spring with pliers. Pull and tap preload spring until it is removed.
- Remove both side gear and clutch pack assemblies, marking each assembly for installation reference. Disassemble side gear and clutch pack assemblies; note order of disassembly for reassembly reference.