4R44E, 4R55E & 5R55E (Aerostar & Ranger)
- Using a screwdriver, remove shift cable from manual control lever at Transmission Range (TR) sensor. Disconnect TR sensor harness connector. Remove manual control lever. Loosen 2 TR sensor retaining screws.
- Install Transmission Range Sensor Aligner (T97L-70010-A). Tighten 2 TR sensor retaining screws. Remove alignment tool. Install manual control lever and tighten to specification. See TORQUE SPECIFICATIONS . Install shift cable. Connect TR sensor harness connector.
- Check for PARK engagement. Start engine and ensure that transmission shifts through all gears properly. If not, check shift cable adjustment. See SHIFT CABLE/LINKAGE . Verify that vehicle only starts in PARK and NEUTRAL and that backup light work.