LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> HVAC System - Compressor Servicing >> NIPPONDENSO 10P13 10-Cylinder >> Air Conditioning Compressor Shaft Seal >> Removal

Air Conditioning Compressor Shaft Seal: Removal

  1. Discharge A/C system using approved refrigerant recovery/recycling equipment. Remove compressor. Drain oil from compressor, and measure drained amount.
  2. Mount compressor in vise, clamping it by mounting ears. Remove clutch assembly and clutch plate shims. Remove front head from cylinder assembly.
  3. Clean compressor front hub area. Remove felt packing and dust seal retainer from inside compressor nose. Using shaft seat Remover/Installer (T87P-19623-BH), Remove seal seat.
  4. Using shaft seal Remover/Installer (T87P-19623-AH), remove seal by pushing downward on shaft seal remover/Installer and rotating clockwise to engage seal tangs. Pull seal from compressor.
scientia non olet · About LEMON Manuals