Inspection & Verification
- Verify customer concern by observing indicators and gauges to determine correct operation with ignition switch in RUN position, with engine off, in START before ignition switch is released and in RUN with engine running.
- Visually inspect mechanical components of instrument cluster as follows:
- Low Brake Fluid Level
- Damaged Engine Oil Filter
- Damaged Vehicle Speed Sensor Gear
- Damaged Washer Fluid Reservoir
- Door Adjustment
- Low Coolant Level
- Low Engine Oil
- Low Washer Fluid
- Stuck Coolant Temperature Gauge Needle
- Stuck Speedometer Needle
- Stuck Tachometer Needle
- Worn Or Damaged Accessory Drive Belt
- Visually inspect electrical components of instrument cluster as follows:
- Blown Fuse
- Damaged Miniature Bulbs
- Damaged Wiring Harness
- Loose Or Corroded Connections
- Damaged Switches and Sensors
- Damaged Instrument Cluster.
- Verify that charging system, safety belt warning chime, turn signals, headlights and cruise control are working properly.
- Inspect wiring harness for obvious signs of shorts, opens, bad connections or damage.