LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1995 >> Probe Base, Automatic >> Repair and Diagnosis (Single Page) >> Suspension >> Front Suspension >> Suspension - Front >> Removal & Installation >> Wheel Hub & Bearings >> Removal

Wheel Hub & Bearings: Removal

  1. Remove steering knuckle/wheel hub assembly. See STEERING KNUCKLE  . Remove and discard grease seal.
  2. Using Puller (T87C-1104-A), Step Plate Adapter (D80L-630-5) and Hub Bearing Remover Adapter (T92C-1104-H), remove hub assembly from steering knuckle. See Fig 1 . If inner bearing race stays on hub, grind a section of race to within .197" (5 mm) of hub. Use a chisel at indent to remove race.
  3. Remove snap ring from steering knuckle. Remove wheel bearing using Puller (T87C-1104-A) and Hub Bearing Remover Adapter (T92C-1104-H). Leave dust shield on steering knuckle, unless damaged.
Fig 1: Removing Hub Assembly From Steering Knuckle
G95A12542Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals