LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1995 >> Probe Base, Automatic >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Adjustments >> Master Cylinder Push Rod >> Gauge Method (M/T Non-ABS)

Gauge Method (M/T Non-ABS)

  1. Remove master cylinder. See MASTER CYLINDER  under REMOVAL & INSTALLATION. Position Master Cylinder Gauge (T87C-2500-A) on end of master cylinder.
  2. Loosen set screw on gauge. Push gauge plunger against bottom of primary piston and tighten set screw. See Figure . Using a vacuum pump, apply 19.7 in. Hg to power brake booster. Invert gauge and install gauge over power brake booster push rod.
  3. There should be no clearance between end of adjustment gauge and power brake push rod. If clearance exists, loosen push rod lock nut and adjust push rod until clearance is eliminated. Install master cylinder, and bleed brakes. See BLEEDING BRAKE SYSTEM  .
scientia non olet · About LEMON Manuals