LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1995 >> Explorer 2D Utility, RWD, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panels - Analog >> Testing >> Oil Pressure Gauge >> With Tester

With Tester

  1. Turn ignition off. Unplug connector from oil pressure sender. See OIL PRESSURE SENDER LOCATION  table. Connect one lead of Rotunda Gauge Tester (021-00055) to sender wire at harness connector. Connect other tester lead to ground. Set ignition switch to ACC position.
  2. Set tester switch to 73 OHMS position. If gauge does not indicate "L", go to next step. If gauge indicates "L", set tester switch to 9.7 OHMS position. If gauge indicates approximately midrange, replace sender. If gauge does not indicate approximately midrange, go to next step.
  3. Inspect sender circuit wiring for shorts and opens. See Figure or Figure . Repair wiring as necessary. If wiring is okay, replace gauge.
OIL PRESSURE SENDER LOCATION

Model Location
2.3L Left Rear Of Engine
3.0L Right Rear Of Engine
4.0L Left Front Of Engine
scientia non olet · About LEMON Manuals