LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1995 >> Explorer 2D Utility, RWD, Automatic >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panels - Analog >> Testing >> Temperature Gauge >> With Tester

With Tester

  1. Turn ignition off. Unplug connector from temperature sender. See TEMPERATURE SENDER LOCATION  table. Connect one lead of Rotunda Gauge Tester (021-00055) to sender wire at harness connector. Connect other tester lead to ground. Set ignition switch to ACC position.
  2. Set tester switch to 73 OHMS position. If gauge does not indicate "C", go to next step. If gauge indicates "C", set tester switch to 9.7 OHMS position. If gauge indicates "H", replace sender. If gauge does not indicate "H", go to next step.
  3. Inspect sender circuit wiring for shorts and opens. See Figure or Figure . Repair wiring as necessary. If wiring is okay, replace gauge.
TEMPERATURE SENDER LOCATION

Model Location
Explorer Left Of Throttle Body
scientia non olet · About LEMON Manuals