LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1995 >> Explorer 2D Utility, 4WD, Automatic >> Repair and Diagnosis >> Transmission >> Transfer Case >> Diagnosis & Overhaul - Borg-WARNER 1354 & 4405 Transfer Case >> On-Vehicle Service >> Front & Rear Output Shaft Oil Seal >> Removal

Front & Rear Output Shaft Oil Seal: Removal

  1. Raise vehicle. Remove skid plate and damper, if equipped. Remove front and/or rear drive shaft. Pull drive shaft and boot assembly out of transfer case front output shaft. Remove output flange lock nut, flat washer, rubber seal and output shaft flange.
  2. Place a drain pan under transfer case, remove drain plug and drain fluid from case. Remove oil seals by prying out or screwing into metal portion of seal and using slide hammer.
scientia non olet · About LEMON Manuals