Removal & Installation (Front Hose)

Open the moonroof approximately 100mm (3.9 inches).
Remove the roof headlining. See HEADLINER .
Use tape to connect one end of the new moonroof drain hose to the old moonroof drain hose end in the cowl side panel.
Disconnect the old moonroof drain hose from the roof opening frame and the A-pillar.
Route and install the new moonroof drain hose when removing the old moonroof drain hose. See Fig 1 .
Discard the old moonroof drain hose.
Apply soapy water to the end of the new moonroof drain hose, and connect the moonroof drain hose to the roof opening frame and the A-pillar. See Fig 2 .
Install the roof headlining. See HEADLINER .

Fig 1: Replacing Front Drain Hose

Courtesy of FORD MOTOR CO.

Fig 2: Securing Front Drain Hose

Courtesy of FORD MOTOR CO.