LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1994 >> Explorer 2D Utility, RWD, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel - Standard >> Testing >> Temperature Gauge >> Without Tester

Without Tester

  1. Turn ignition off. Unplug connector from temperature sender located left of throttle body. Connect one terminal of 10-ohm resistor to sender wire at harness connector. Connect other resistor terminal to ground. Turn ignition on. Observe gauge. Gauge pointer should indicate close To "H".
  2. Substitute 73-ohm resistor for 10-ohm resistor. Gauge pointer should be close to "C" mark. If gauge indications are not as indicated, replace gauge and retest. If indications are as specified, replace temperature sender.
scientia non olet · About LEMON Manuals