LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1994 >> Explorer 2D Utility, RWD, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel - Standard >> Testing >> Oil Pressure Gauge >> Without Tester

Without Tester

  1. Turn ignition off. Unplug connector from oil pressure sender located near power steering pump. Connect one terminal of 10-ohm resistor to sender wire at harness connector. Connect other resistor terminal to ground. Turn ignition on. Observe gauge. Gauge should indicate at midrange on scale.
  2. Substitute 73-ohm resistor for 10-ohm resistor. Gauge pointer should be close to "L" mark. If gauge indications are not as indicated, replace gauge and retest. If indications are as specified, replace oil pressure sender.
scientia non olet · About LEMON Manuals