LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1994 >> Crown Victoria Base >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panel - Electronic >> Testing >> Pinpoint Test Fa - Instantaneous Or Average Fuel Economy Always Indicates 0 Miles/Gal Or 99 Miles/Gal

Pinpoint Test Fa - Instantaneous Or Average Fuel Economy Always Indicates 0 Miles/Gal Or 99 Miles/Gal

  1. If message center displays 0 MPG (99L/100 KM), go to next step. If message center displays 99 MPG (0L/100 KM), go to step 3).
  2. Drive vehicle. If speedometer works properly, replace EIC.If speedometer does not operate properly, go to PINPOINT TEST DA  .
  3. Inspect Dark Blue/Light Green wire between pin No. 34 of PCM and EIC connector C255 pin No. 22 for shorts or open. See Figure . If wire is okay, go to next step. Repair wire as necessary.
  4. Turn ignition off. Press and hold E/M and left arrow of SELECT button simultaneously. While pressing buttons, start engine. Release buttons when cluster lights. Allow engine to idle during remainder of test. If odometer does not flash, go to next step. If odometer flashes, replace EIC.
  5. Observe odometer. If odometer displays 33 33, 34 34, or 35 35, go to next step. If display is anything else, repeat step 4).
  6. Press right arrow of SELECT button once. Observe display. If display is the same as it was in step 1), go to next step. If display is not the same as it was in step 1), repeat step 4).
  7. Press E/M and left arrow of SELECT button simultaneously once. Observe odometer. If left 2 characters are OA, go to next step. If left 2 characters are anything else, repeat step 4).
  8. Press right arrow of SELECT button twice, quickly. Left 2 characters of odometer will change to 1b. Repeat this step 4 times until left 2 characters are 5f. Observe right 4 characters of odometer. This display is pulse frequency from fuel flow meter, and should change with engine speed. 0000 indicates no fuel flow pulses are being received from PCM. If 0000 appears, turn engine off. Repeat step 3). If Dark Blue/Light Green wire is okay, replace PCM. If any number but 0000 appears, replace EIC.
scientia non olet · About LEMON Manuals