Clutch Slave Cylinder: Remove & Replace
WARNING: This page is about the Bronco 5.0 N, Automatic, 4R70W, which is a different variant/trim than selected.
Includes: R&I Transmission and Bell Housing (where necessary).| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| ZF5 Trans ID | 5.7 | 4.3 | C | |
| Additional Procedure: CLUTCH SLAVE CYLINDER: Remove & Replace: | ||||
| w/Skid Plate add | 0.2 | C | ||
| Where necessary to R&I Carpet add | 0.8 | C | ||
| Combination Procedure: CLUTCH SLAVE CYLINDER: Overhaul: | ||||
| 0.5 | B | |||