LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1993 >> Crown Victoria Base >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Suspension - Rear Electronic Air >> Testing & Diagnosis >> Service Bay Diagnostics >> Test Procedure (Auto Test)

Test Procedure (Auto Test)

  1. Remove all extra loads from luggage compartment. Turn air suspension switch, located on right side of luggage compartment, off, then on. Attach tester according to manufacturer's instructions.
  2. Start engine. If engine cannot be started, connect battery charger to maintain battery level and turn ignition switch to ON position. Wait 5 seconds, then depress Super Star II tester button so it remains in TEST position. Code 10 should be displayed. If Code 10 is displayed, go to next step. If Code 80 is displayed, go to TEST M (CODE 80), BATTERY VOLTAGE LOW. If no codes are displayed, go to TEST N, UNABLE TO ENTER SERVICE BAY DIAGNOSTICS.
  3. Code 10 will be displayed for up to 2 minutes. DO NOT put any weight on vehicle while code 10 is displayed. When Auto Test is complete, Code 12 (test passed) or Code 13 (test failed) will be displayed.
scientia non olet · About LEMON Manuals