LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1993 >> Crown Victoria Base >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Suspension - Rear Electronic Air >> Removal & Installation >> Upper Control Arm & Axle Bushing >> Removal

Upper Control Arm & Axle Bushing: Removal

  1. Turn air suspension switch, located in luggage compartment, to OFF position. See Figure . Raise vehicle on hoist and support frame side rails. Support rear axle. Lower axle and support axle under differential pinion nose as well as under axle. Unsnap parking brake cable from upper control arm retainer.
  2. Disconnect height sensor from ball stud on left upper control arm. Remove and discard nut and bolt securing upper control arm to axle housing. Disconnect arm from housing. Remove and discard nut and bolt securing upper control arm to frame bracket and remove control arm.
scientia non olet · About LEMON Manuals